To sum it up, just commence examining the price of the powder to start with. Concerning H-one hundred ten and win 296 (that are both precisely the same powder), the H-110 most the time is the inexpensive powder. On 300mp, it hard to find it within a 8lb jug, and Except yow will discover it within a 8lb jug, or your dealer will Slash you a price on eight-1lb cans for a 8lb jug price tag, then H-a hundred and ten is usually the less expensive powder that you can discover as an alternative.



The equilibrium is for powder. Considering that your crimp goes in to the wad column/hull your powder is just not bulky plenty of which lets the shot/wad column to established too deep while in the hull. Because you have extreme limitations with component availability inside the 410 gauge its in all probability required to adjust powder in an effort to solve the challenge.

Thanks a great deal for responding to my issue. I a short while ago bought a different Spolar. I didnt have this problem with my older Spolars.

I've questioned about Alliant Steel for large pistol circumstances (.44 Mag and scorching .45 Colts) but I believe the issue would be the flakes are way too large and you'd really have to weigh each individual cartridge. :barf:

LilGun burns up my hulls much too fast as does Alliant 410. I've also tried nearly every thing else. Will not recall my gripes Together with the Some others, but I have been utilizing H110 quite a long time and often have already been delighted with it.

And Sure, I've used all 3 powders, and could drop flats of them on stations in mixes, therefore visit our website you would not have the ability to notify which shell had what powder, since the speeds and patterns are so near jointly at the 1350fps selection, there isn't any practical big difference in functionality of your shells.




Cost is below $five and may overcome your powder migration challenge. It screws straight towards the cost bar, you don't use either the brass washer or grommet.

Take note: Don't trust the charts!!!! Do a handful of throws Along with the new bushing inside your device and pounds the throws to confirm that you'll be obtaining the proper grain drops.

This can be an more mature thread, you might lt-30 powder not get a reaction, and will be reviving an aged thread. Please contemplate creating a new thread.

As pointed out, the crimps on both 28 gauge and .410 bore STS hulls will come to be unusuable just after 5 or 6 reloads. If you're able to choose them up free of charge They are really worth utilizing awhile but they don't seem to be value spending nearly anything for.

Supposedly the melt away fee is somewhat more rapidly than 2400 but, Should the maker will not suggest it, I wouldn't get it done. I'm advised that Alliant 410 is also sensitive to low temps.

Designed by showin




The best ballistic professionals and high high-quality components are introduced together to make sure each gun is healthier served with Accurate Powders.

I am able to confirm from initially hand expertise the 13gr. load performs like a allure which has a load of 3 @ 0.395" balls; my loads were being plastic shells but I see no cause why it would not do the job with full size metallic shells.